Home » Technical Support » Video Tutorial » OPS computer installation video

OPS computer installation video

Ops are commonly used devices in interactive exhibitions. The video explains common problems and solutions when using an operations computer, such as how to install an operations host? How to replace the motherboard and pair it with the remote control, and how to use it quickly.

The following is a complete tutorial on installing and debugging a computing computer, including how to connect a projector, how to replace the computer motherboard battery, how to use a one click on/off remote control, how to replace the battery of a one click on/off remote control, etc., to ensure your experience is safe and reliable


How to connect a host to a projector

Firstly, check if the accessories are complete. They include the projector, projector power supply, host, host, host power supply, host remote control switch, HDMl cable, serial cable, wireless keyboard and mouse, and USB extension cable. Firstly, connect and install the power cables of each device, then connect the HDMl cable to the projector and the host serial port cable. The same operation is required, with one end of the USB cable connected to the host and the other end as a backup.

How to use a remote control switch

In general, devices are installed in higher positions and it is not convenient to manually control them, so remote control is required. You can mainly control the switch of the device by standing near it and pressing the remote control to observe whether the indicator light is on.

How to replace the OPS mainboard battery? 

The replacement of the OPS motherboard battery is an unavoidable issue that we cannot avoid during use. How should we replace it with a new battery? First, you need to use a Phillips screwdriver to open the outer protective case and find the button battery installation position under the host graphics card. Remove the old battery and replace it with a new one, then reset it to complete the installation.

The battery of the wireless remote control needs to be replaced. When you press the switch and the indicator light on the remote control does not light up, it means that you need to replace the battery. You need to remove the screw on the back of the remote control and open the back cover to see the battery compartment. Replace the battery cover with a new one and install the screw to complete the installation.

How to pair a remote control with a controller? First, pry open the cover of the controller and press the reset button on the cover. The green light will light up to indicate success. Then, press the switch of the remote control and do not let go. If you hear a beep, the pairing is successful.

Copyright© 2013 KLEADER LTD All Rights Reserved | Sitemap